Cutting Die for Cold Heading Die

Cutting Die for Cold Heading Die

There are two ways to make a bolt or screw out of a piece of round stock. First, there is screw machining, that cuts excess metal away from a piece of bar stock until what remains is the shape you want.

Product Details

Basics of the Cold Heading Process

There are two ways to make a bolt or screw out of a piece of round stock. First, there is screw machining, that cuts excess metal away from a piece of bar stock until what remains is the shape you want. These fasteners start out with a bar stock size equal to the largest diameter of the fastener being made. This process produces a fastener with scrap material left over. The second method, cold heading, forces a piece of wire stock into the desired shape without removing any metal. When finished, the fastener will be produced without wasted material.


Screw machined parts are made by lathes or CNC’s (computer, numerical controlled machines). Cold heading is done by a variety of cold heading machines. It involves moving metal through a series of dies to form the part to its desired shape.


Cold heading machines use a coil of wire and form the wire into desired parts at very high rates of speed allowing the cold-headed parts to be made very quickly and economically. The process begins by loading a large coil of wire in front of the cold heading machine. The wire is purchased in a condition called spherodized anneal. This special condition allows the material to be formed without cracking.


The wire is then pulled through a wire draw box to change the stock diameter to the specific diameter required to manufacture the fastener. Running the wire through a draw box makes the wire shape very round with a tolerance of .001. This is very important to holding size on the final parts after it is cold headed. A wire straightener can also be added which will align the wire prior to going into the cold heading machine. Straightening the wire is especially important on long parts.


After the wire has been successfully drawn to size, the wire enters the inside of the cold heading machine. The wire goes through a cut-off die and continues until it reaches a wire-stop. Once it reaches the wire stop, a cut-off knife moves across the wire, cutting it off to a specific length. This is referred to as the cut-off slug.

Hot Tags: cutting die for cold heading die, China, manufacturers, suppliers, factory, wholesale, customized, cheap, design, precision

Inquiry

You Might Also Like